pro e 4.0 Some important installation instructions, in addition to Article 7, the other proe 3.0
also be applicable to the installation package to download the iso winrar can extract, you can also use the virtual drive software loaded!
recommended installed in d: \ ptc, and within ptc directory create three directories
license
work permit to hold the end of the installation boot directory
temp setting can be used to set the trail file directory (config. pro in the use of trail_dir d: \ ptc \ temp)
1, set the environment variable lang = chs (not necessary, if you did not install the program interface to display Chinese garbage can skip)
2, setup.exe where the path can not contain Chinese, Otherwise, no response to Operation
3, production licenses, replace ptc_licfile.dat the card number is lower left corner of the Setup program displays the host id
4, the installation path is best not to drive in the c, permits are not on the c drive (reinstall the system later can be used directly without reloading proe)
5, to specify the license server choose the third item "Locked license file"
6, in proewildfire 4.0 \ i486_nt \ obj directory, run ptc.pro engineer.wildfire.4.0.win32- patch, until patching down.
7, in proewildfire 4.0 \ mech \ i486_nt directory bin directory and run separately the two ptc ptc.pro mechanica.wildfire.4.0.win32-patch.exe, until patching down.
8, where the proe1.psf set mechnic path, or else run the mechanic to be wrong